Tyco iSTAR eX, Installation And Configuration Manual

Page: 17 / 232

Preface
iSTAR eX Installation and Configuration Guide xvii
FCC Class B Notes
When using properly grounded and shielded cabling for monitor point and
control point wiring, iSTAR eX meets the requirements for an FCC Class B
device, and the following notice applies:
Canadian Radio Emissions Requirements
This digital apparatus does not exceed the Class A limits for radio noise
emissions from digital apparatus set out in the Radio Interference Regulations
of the Canadian Department of Communications.
Le present appareil numerique n’emet pas de bruits radioelectriques
depassant les limites applicables aux appareils numeriques de la class A
prescrites dans le Reglement sur le brouillage radiolelectrique edicte par le
ministere des Communications du Canada.
NOTE
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC rules. These limits
are designed to provide reasonable protection against harmful
interference in a residential installation. The equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one of more of the following measures:
„
Reorient or relocate the receiving antenna.
„
Increase the separation between the equipment and receiver.
„
Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
„
Consult the dealer or an experienced radio/TV technician for help.