Instruction Sheet
PRO-CRIMPER* III Hand
Crimping Tool Assembly 58564-1
408-4075
LOC B
1 of 5
E2009 Tyco Electronics Corporation, Harrisburg, PA
All International Rights Reserved
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names used are the property of their respective owners.
TOOLING ASSISTANCE CENTER 1-800-722-1111
PRODUCT INFORMATION 1-800-522-6752
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
05 MAY 09 Rev B
with Die Assembly 58564-2
PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use and low volume
applications. A wide selection of powered application equipment for extended-use, production operations is available.
354940-1 (See 408-9930)
Locator
Front of Tool
(Locator Side)
Ratchet
Adjustment
Wheel
Back of Tool
(Wire Side)
Pivot Pin
Moving Jaw
Moving Handle
Stationary
Handle
Assembly
PRO-CRIMPER III Hand
Crimping Tool Frame
(Supplied with
Die Assembly)
Die
Assembly
Stationary Jaw
The PRO-CRIMPER III Hand Crimping Tool is a Commercial" grade tool and
is designed primarily for field installation, repair, maintenance work, or
prototyping in industrial, commercial, or institutional applications. Product
crimped with this tool will meet the crimp height requirement for hand tools in
the appropriate 114 application specification, but may not comply with other
feature parameters of the specification. Tyco Electronics offers a variety of
tools to satisfy your performance requirements. For additional information,
contact the Technical Assistance Center at 1-800-722-1111.
TE
TE
Contact
Wire
TE
Die Assembly
TE
Locator Assembly
{
Contact
Family
}
Size (AWG)
Insulation Diameter
(mm [In.])
Strip Length
(mm [In.])
Uni ersal
20 to 18
2.01 to 2.69
[.079 to .106]
58564-2
58516-1
Universal
Power
Contacts
16
2.49 to 3.30
[.098 to .130]
2.69 to 3.71
[.106 to .146]
Contacts
26 to 22
.89 to 2.90
[.035 to .114]
{
Supplied with die assembly. Also available separately.
}
Contact the Tooling Assistance Center or Product Assistance Center. (see below).
Figure 1
1. INTRODUCTION
PRO–CRIMPER III Hand Crimping Tool
Assembly 58564–1 consists of Die Assembly
58564–2 and PRO–CRIMPER III Hand Crimping Tool
Frame 354940–1. The die assembly consists of
crimping dies and a locator assembly.
Read these instructions thoroughly before crimping.
Dimensions on this sheet are in millimeters [with
inch equivalents provided in brackets]. Figures
and illustrations are for identification only and are
not drawn to scale.
Reasons for reissue are provided in Section 11,
REVISION SUMMARY.
NOTE
i
