409-10042
DT-3000 Machines 1725100-[ ]and DT-5000 Machines 1725800-[ ]
Rev E
4 of 22
Tyco Electronics Corporation
Denotes an imminenthazard which may resultin moderate or severe injury.
Denotes a condition which may resultin productor equipmentdamage.
Highlights special or important information.
Reasons for reissue are in Section 9, REVISION SUMMARY.
The various applicators that can be used in these machines are covered in applicator instruction sheets packaged with
each applicator. Applicator instruction sheets provide information on applicator installation, care, and adjustment.
All numerical values are in metric units [with U.S. customary units in brackets]. Some commercial items may
contain non-metric hardware.
Figure 2 provides specifications and requirements for these machines.
Capacity (Maximum Crimp Force): DT-3000 Machines
13.3 kN [3,000 lb]
DT-5000 Machines
22.2 kN [5,000 lb]
Deflection: 0.13 mm [.0046 in.] Maximum per 4,448 Newtons [1,000 lb] Crimp Force
Noise: Less than 76 dBa Typical at Operator Position with Standard Mechanical Feed Applicator
Weight: 64 Kilograms [143 lb]
Height: 510 mm [20 in.] Without Reel Supports
Electrical: 100-240 Vac, 50/60 Hz, Single-Phase Current
Air: 620-760 kPa [90-110 psi], 2.83 liters/sec (6 scfm)
When Required for Use with Air-Feed Applicators
Figure 2
Physical Environment: Temperature: 4.4
°
-40
°
C [40
°
-104
°
F]
Altitude: Not Applicable
Relative Humidity: Less than 95% (non-condensing)
Transportation and Storage: Store in a clean, dry environment after coating all surfaces
lightly with a rust-preventing oil.
DANGER
CAUTION
!
NOTE
i
NOTE
i
NOTE
i
