409-10042
DT-3000 Machines 1725100-[ ] and DT-5000 Machines 1725800-[ ]
Rev E
12 of 22
Tyco Electronics Corporation
released in mid–cycle and pressed again, the crankshaft will continue to rotate in the forward direction at
the default reduced speed. If the machine does not complete the cycle, either adjust the speed control
knob (as described below), or complete the cycle using the footswitch (at a speed determined by the
speed control knob) after the Jog button has been pressed and released.
Holding the Jog button down for more than five seconds will cause the machine to “err.” To clear the error,
“power down” the machine, clear the problem area, and then “power up” the machine again. An alternate
method of clearing the error is to hold down the foot pedal until the green status indicator stops flashing. If
the motor is stalled, it may be necessary to manually cycle the machine to the home position. Refer to the
CAUTION and DANGER statements below for the proper manual cycling procedure.
While in the Jog mode, attempting to complete a crimp cycle with terminals and wire in the applicator may cause the
motor to stall. Although the machine can terminate some smaller terminals and wire, it may be necessary to turn off"
the machine and manually cycle the machine to the home position. Manually cycle the machine by removing the
access cover on the end of the motor (Figure 7), engaging the hex key with a 6-mm hex wrench, and rotating the key
to manually rotate the motor.
To avoid personal injury, be sure to remove the hex wrench before operating the machine under power. Be sure to
replace the access cover.
To avoid personal injury, exercise caution when jogging or operating the machine.
CAUTION
!
DANGER
DANGER
