Laser Welding Machine
Address: 18 South Liu Fang Yuan Road,Sintec Industrial Park, Wuhan Hubei, 430205 PR China
Tel: 0086 27 65523998 Mobile/WhatsApp/Wechat:0086-17371095681
Web:http://www.txtlaser.com/ ; E-mail: [email protected]
第
33
页
6.2 Laser
1) Note: When using the laser, the grounding wire of the equipment should be
grounded reliably.
2) There are no built-in parts for use, all repairs should be carried out by
qualified laser manufacturer personnel, in order to prevent electric shock,
please do not damage the label and open the cover, otherwise any damage to
the product will not be covered by warranty.
3
）
The output head of the laser is connected with the optical cable. Please
handle the output head carefully when using it to prevent dust or other pollution.
Please use special lens paper when cleaning the lens at the output end. When
the laser is not installed on the system equipment and does not emit light,
please cover the optical isolator protective cover to avoid dust pollution. The
bending angle of the optical cable should not be too large, so as not to break
and fall off.
4) If the laser is not used according to the prescribed method, the protective
function it produces will be weakened. Therefore, this product must be used
under normal circumstances.
5) When the laser is running, it is strictly forbidden to install the output
collimator.
6) The laser has three fans at the tail plate for heat dissipation, and it must be
ensured that there is enough airflow to dissipate heat. Leave at least 10cm of
ventilation space before and after the laser.
7) Do not look directly at the output head, and make sure to wear the laser
safety eye for a long time when operating the machine.
8
）
Power interruption is very harmful to the laser, please provide continuous
power.
The above are the precautions for use safety, please refer to the laser
user manual carefully for the specific maintenance details.
