Package
Overview
Installation
1
2
3
4
Warning
and
Caution
■
If the product does not work properly, please contact your dealer
or the nearest service center. Never attempt to disassemble the
camera yourself. (We shall not be responsible for any problems
caused by unauthorized repair or maintenance.)
■
Keep away from liquid while in use.
■
In the use of the product, you must be strict compliance with the
electrical safety regulations of the nation and region. When the
product is mounted on wall, the device shall be firmly fixed.
■
Do
not
use
camera
beyond
specified
voltage
range
.
■
Do not drop the camera or subject it to physical shock.
■
Avoid touching the camera lens.
■
If cleaning is necessary, please use clean cloth to wipe it gently.
If the device will not be used for a long time, please cover the lens
cap to protect the device from dirt.
■
Do not aim the camera at the sun or extra bright place.
■
Do not place the camera in extremely hot, cold (the operating
temperature shall be -10˚C~45˚C), dusty or damp locations, and do
not expose it to high electromagnetic radiation.
■
To avoid heat accumulation, good ventilation is required for
operating environment.
Quick
Start
Guide
Network
Camera
Camera
Drill template
Quick
start
guide
CD
2 tapping screws
2 plastic plugs
■
Please read this instruction carefully before using the product and
keep it for further reference.
■
All the examples and pictures used here are for reference only.
■
The contents of this manual are subject to change without notice.
5
11
6
12
13
15
14
16
1
7
2
8
3
9
4
10
STATUS
LINK
ALARM
ALARM
DC12V
RST
I
G
O
LAN
1
3
2
4
5
6
7
8
9
10
11
12
14
15
16
13
Lens
IR LED ( ON: visible)
Microphone
PIR (Passive Infrared) sensor
Power indicator
Network indicator
Alarm indicator
Light sensing
Ethernet connector & PoE
Speaker
Alarm I/G/O
Power connector
Reset or WPS
Micro SD card slot
3-axis bracket
Mounting base
●
Alarm Connections
:
I
:
Alarm
input interface;
O
:
Alarm
output interface; G: Grounding
Alarm input: Connect the cables of the sensor to I and G interfaces.
Alarm output: Connect the cables of the alarm output device to O and G
interfaces.
230°
71°
360°
●
Indicators
Power indicator: Green: the camera is started successfully.
Network indicator: Flashing blue: the camera is connected
to the wired network successfully.
Alarm indicator: Red: alarms are triggered.
●
Reset
Press RST about 10s when the camera is powered on to
restore the default settings.
●
3-axis Bracket Adjustment
The camera can be placed on the desktop or installed on the wall.
Please make sure the wall is strong enough to withstand 3 times the
weight of the camera. The steps of wall mounting are as follows.
①
Attach the drill template to the place where you want to fix the
camera. Then drill the screw holes on the wall according to the drill
template.
②
Peel off the drill template and then insert the plastic plugs and
screws into the screw holes. Please leave a little clearance between
the wall and the screws.
●
WPS
WPS (Wi-Fi Protected Setup): Press the WPS button on the router
and then press the RST button on the camera within 120s to quickly
connect the Wi-Fi. Pressing the RST button on the camera and then
pressing the WPS button on the router will work as well. The red
alarm indicator will flash if the Wi-Fi is connected.
