12
Network Camera User Manual
sent into those addresses.
Trigger FTP
: If “Trigger FTP” and “Attach Picture” are checked, the captured pictures will
be sent into FTP server address. Please refer to FTP configuration chapter for more details.
3. Click “Save” button to save the settings.
4. Set the schedule of the fire detection. The setup steps of the schedule are the same as the
schedule recording setup. (See
4.2
Temperature Measurement
Temperature Measurement: When detecting the temperature of the pre-defined point/line/area
exceeds the temperature threshold value, alarms will be triggered.
Click Config
Temperature measurement to enter the following interface.
1. Click “Enable” and set the alarm holding time.
2. Set alarm trigger options. The setup steps are the same as motion detection. Please refer to
3.
Set thermography rule. Click the “Area” tab to go to the following interface.
The thermography rule type includes Point, Line Area.
Point setting
: After the type is set to “Point”, click “Draw Area” and then drag the mouse in
the image on the left side to move the point. Click the “Stop Draw” button to stop drawing.
Up to 10 points can be set in the above interface.
Line setting
: After the type is set to “Line”, click “Draw Area” and then drag the mouse in the
image on the left side to draw a line. Click the “Stop Draw” button to stop drawing. To ensure
the accuracy of temperature measurement, it is recommended to set not more than two lines at
the same time.
Area setting
: Click the “Draw Area” button and then click around the area where you want to
set as the alarm area in the image on the left side (the alarm area should be a closed area).
Click the “Stop Draw” button to stop drawing. Click the “Clear” button to delete the alarm
area. Click the “Save” button to save the settings. To ensure the accuracy of temperature
measurement, it is recommended to set not more than two areas at the same time.
