TVT Digital Smart Management Terminal, User Manual, Page: 87 / 137

AI/Event Management SMT User Manual
79
automatically when the sensor alarm is triggered. You need to set the delay time and the
schedule of the alarm outputs. See 12.7.1 Alarm-out for details.
Buzzer : if enabled, the system will begin to buzz when the sensor alarm is triggered. To set the
delay time of the buzzer, please see 12.7.4 Buzzer for details.
Pop-up Video : After camera setting, the system will pop up the corresponding video
automatically when the sensor alarm is triggered. To set the duration time of the video, please
see 12.7.3 Display for details.
Pop-up Message Box : if enabled, the system will pop up the corresponding alarm message box
automatically when the sensor alarm is triggered. To set the duration time of the message box,
please see 12.7.3 Display for details.
E-mail : if enabled, the system will send an e-mail when the sensor alarm is triggered. Before
you enable the email, please configure the recipient’s e-mail address first (see 14.1.5 E-mail
Configuration for details).
12.4 Motion Alarm
Motion Alarm : when the motion object appears in the specified area, it will trigger the alarm.
You should enable the motion of each camera first and then set the alarm handling of the
camera to complete the whole configuration of the motion alarm.
12.4.1 Motion Configuration
①
Click Start

Settings

Camera

Motion Settings to go to the following interface.
②
Select the camera, enable the motion and set the sensitivity and duration of the camera.
Sensitivity : the higher the value is, the more sensitive it is to motion. You should adjust the