TVT Digital Smart Management Terminal, User Manual, Page: 85 / 137

AI/Event Management SMT User Manual
77
the schedule of the alarm outputs. See 12.7.1 Alarm-out for details.
Pop-up Message Box : if enabled, the system will pop up the corresponding alarm message box
automatically when the over temperature alarm is triggered. To set the duration time of the
message box, please see 12.7.3 Display for details.
12.2 Mask Settings
Click Start

Settings

AI/Event

Temperature/Mask to go to the following interface.
①
Turn on ―Mask Off‖. Then the non-mask detection results of the IP panels/cameras will be
received by the device and trigger an alarm. In live view mode, you will view the non-mask
alarm information (―mask off‖) displayed under the captured face picture in the comparison
interface and real-time warning interface.
Note: Before using this function, please ensure that mask detection is supported by the added
IP panels/cameras and it has been enabled.
②
Enable ―Trigger settings‖ and then select the schedule. Select ―APP Push‖, ―Pop-up
Message Box‖ and ―Alarm-out‖ as needed. The setting steps of the alarm linkage are the same
as that of the body temperature settings.
③
Click ―Apply‖ to save the settings.
12.3 Sensor Alarm
To complete the entire sensor alarm settings, you should enable the sensor alarm of each
camera and then set up the alarm handling of each camera.
①
Click Start

Settings

AI/Event

Sensor to go to the following interface.