Changing the mode of your CORIOview™
Your CORIOview can run in two modes, classic mode and dynamic mode.
If you find that the mode you’re using is too complex, or doesn’t have the feature set you need, you can switch
modes in
>
General
.
Risk of losing settings
When you switch modes, CORIOview only keeps your network settings. Consider making a backup copy before you switch, in
case you want to switch back again.
Read more about making a backup
I don't know which mode I'm using
Look at the front panel buttons.
On the front panel, press the PRESET button four times.
n
If the PRESET button stays lit after multiple presses, your CORIOview is in classic mode.
n
If the PRESET button alternates between lit and unlit with each press, your CORIOview is in dynamic mode.
Or, if you're using CORIOgrapher, connect to your CORIOview and take a look at the dashboard. If you see
circles, your CORIOview is in classic mode. If you see squares, your CORIOview is in dynamic mode.
Which mode do I want?
Classic mode
Classic mode gives you more control over features like audio, transitions, borders, and rotating your output.
You can more fully customize your layout, choose your output resolution, and even rotate your displays into
portrait mode. Use classic mode for more sophisticated activities, such as broadcast management and medical
applications.
If you’ve had a CORIOview for a while running a firmware version below 409, you’re already using classic mode.
Dynamic mode
Dynamic mode automates more of the features of your CORIOview. It has a simplified interface, automatic
layouts, and is easier to use, even if you’re not very experienced. As a result, dynamic mode is better for
activities like running meetings and lectures, and security monitoring.
To change the mode of your CORIOview
1. From
>
General
, select
Choose your operating mode
.
2. Select a mode.
CORIOgrapher restarts.
PDF-MWP-DYN-V1.20 tvONE
37
