Page 74
an electric shock, which may lead to fire or personal injury
.
Use caution when cleaning the printer or autoclave. Splashing
water, cleaning solution or other liquids into the printer can cause
fire or electrical shock
.
Never touch the thermal head immediately after printing as it
becomes very hot. Make sure that the thermal head is cool before
setting papers or cleaning the thermal head.
Power OFF the autoclave in any of the following cases:
The printer does not recover from an error.
Smoke, strange noise or smells erupt from the printer.
A piece of metal or any liquid touches the internal parts or slot of the
printer.
7.
INSTALLATION INSTRUCTION
7.1.
Lifting and Carrying
Cautions!
Any time the autoclave is to be moved, make sure that the
electric cord is disconnected from the power, and there is
no pressure in the chamber or steam generator.
1. Disconnect the power supply cord.
2. Drain the water from both reservoirs (see sec 10.4)
Attention! The pressure of the generator does not decrease
immediately when the equipment is turned off. Carefully,
using a tool, pull on the ring of the safety valve located in
the mineral free water reservoir to relieve the pressure. USE
CAUTION THE STEAM WILL BE HOT!
Do not drop the device!
Note: Lifting straps have been provided with this unit. Lifting straps are
for one time use and should be removed and discarded after
initial set up.
7.2.
Unpacking the autoclave
Unpack the autoclave and inspect for mechanical damage upon
receipt. Observe packing method and retain packing materials until the
unit has been inspected. Mechanical inspection involves checking for
signs of physical damage such as: scratched panel surfaces, broken
knobs, etc.
To avoid injuries, lifting and carrying should be done with at least two
persons
7.3.
Placing
CAUTION: The installation described in this section must be
done only by an authorized technician.
