Caution!
Before filling the reservoir, verify that the autoclave is idle and there is no
pressure in the chamber.
7.3
Filling water in the reservoir
Note: Use only water having the characteristics stated in Water Quality.
Using tap water will clog the system and invalidate the manufacturer’s
guarantee.
To fill water in the reservoir:
Lift up the water reservoir cover (see below).
Pour water into the reservoir through the water filter on top of the autoclave
unit.
In case you fill too much water, it will spill on the counter.
The clean water level indicator will change from a red water droplet symbol to
a blue water droplet, as shown below:
Page 33
Summary of Contents for AMS10-120-T
