At the bottom of the list (most quickly reached by pressing UP from the first item in the list) we
find the option to clear all mixes in the Mixer screen.
01 Simple 4-CH
Creates a basic four channel fixed wing model with 100% weighting on each of the channels.
Channel order is determined by the setting in Radio Setup page 1/11. Note that applying this
template overwrites anything already set for channels 1 to 4.
02 T-Cut
Inserts a mix line for the throttle channel that replaces throttle stick input by -100% when the
THR.CUT switch is ON. When the switch is OFF, the throttle stick is immediately active.
03 Sticky T-Cut
Replaces throttle stick input by -100% when the THR.CUT switch is ON. When the switch is moved
to OFF, the throttle stick remains inactive until moved to the throttle closed position. (The “sticky”
mechanism is located on CH14, which is not sent to the receiver.)
04 V-Tail
Inserts mixes for both rudder and elevator input into the two channels used for the tail servos. When
the elevator stick is moved up, both surfaces move up. When the rudder stick is moved right, the left
surface goes up/right and the right surface goes down/right. Note that this mix may overwrite existing
mixes.
05 Elevon/Delta
Similar to V-Tail but inserts mixes for aileron and elevator into the channels that control the elevon
servos. When the elevator stick is moved up, both surfaces move up. When the aileron stick is
moved right, the left surface goes down and the right surface goes up. Note that this mix may
overwrite existing mixes.
Ersky9x Explained – version 1
page
41
of 45
