ORIGINAL
Page 11
4.3
In general
⚠
Observe the following:
•
During
assembly/mounting
ensure that no parts, fittings or cables are damaged or
squeezed when changing between all the possible positions. This applies for both the bed
and TurnAid T4.
•
Leave the bed in a position where no one can get injured. If there is a person in the bed,
TurnAid T4 must be folded to "
bed rail-position
". In this case, do not forget that the
turning sheet must be tightened as much as possible.
•
If there is NO person in the bed, you can leave TurnAid T4 in
"folded-position".
•
Do NOT expose the connection cable for TurnAid T4 to unnecessary pulls or sharp bends.
In case of a damaged cable, disconnect TurnAid T4 from the power supply and call for a
service technician.
•
Connect the TurnAid T4 plug to power from electrical outlet.
•
When applying other equipment with tubes, wires, or the like please take special care in
connection with all moving parts. Cf. chapter 6.14.
4.4
Inspection upon receipt
Upon receipt of TurnAid T4 check packaging. If the system shows any sign of damage, please
do not hesitate to contact TurnAid ApS.
4.5
Inspection prior to daily use
1.
From top of mattress to top of bed rail (
"bed rail-position"
) there has to be a
minimum of 230 mm.
2.
The TurnAid T4 length adjustment bar must be placed at the foot end of the
bed.
3.
From the end of the TurnAid T4 to the headboard or footboard of the bed there have
to be min. 25 and 60 mm.
