Lit. No. 85759, Rev. 00
11
November 15, 2018
3. Secure sprayer frame in place with supplied
3/8" x 1-1/2" hex cap screws, 3/8"
fl
at washers,
and 3/8" locknuts.
If the mounting holes are not
directly over the truck box supports, the truck
bed must be braced to the frame to prevent
buckling or deforming the truck bed.
NOTE: Pay special attention when drilling or
clamping dissimilar metals to aluminum bodies.
Galvanic corrosion can occur if not handled
properly. Contact vehicle manufacturer for
recommended attachment practices.
ASSEMBLY / INSTALLATION
During assembly, check and test completed assembly
as directed in this manual. Serious injury could result
from chemical leaks if sprayer is improperly assembled.
IMPORTANT: DO NOT modify sprayer design.
NOTE: To prevent leaks, use a thread-sealing
compound on all threaded connections. Do
not use Te
fl
on
®
tape, as fragments will clog the
spray nozzle. Clamped connections may require
periodic retightening.
1. Lift main assembly using the four lift points and
position onto vehicle. Center sprayer system left to
right on the vehicle.
2.
Construct Sill Spacer:
Measure the distance
from the front end of the sprayer frame to the
front of the vehicle bed and make a spacer from
2" x 8" lumber to
fi
t that area.
Failure to install this
spacer could result in damage to the sprayer.
INSTALLATION INSTRUCTIONS
Te
fl
on
®
is a registered trademark of E. I. du Pont de Nemours and Company.
WARNING
Always shut vehicle OFF before attempting to
attach, detach, or service sprayer system.
WARNING
Never attempt to take a unit off a truck with
liquid in it.
WARNING
Overloading could result in an
accident or damage. Do not exceed
GVWR or GAWR ratings as found
on the driver-side vehicle door
cornerpost. See Speci
fi
cations section to
determine maximum volumes of spraying
material.
WARNING
New untitled vehicle installation of a sprayer
system requires National Highway Traf
fi
c
Safety Administration altered vehicle
certi
fi
cation labeling. Installer to verify that
full sprayer does not exceed GVWR or GAWR
rating label and complies with FMVSS.
3/8" x 1-1/2"
Hex Cap Screw
3/8" Flat
Washer
3/8"
Locknut
Front of
Truck Bed
Measure distance.
18"
Fit to vehicle.
Measured
Distance
Frame Spacer
Built to Fit
Summary of Contents for US1000-1
Page 2: ......
