Maintenance
Clean Debris From Machine
Service Interval: Before each use or daily
1.
Stop engine and wait for all moving parts to stop.
Engage parking brake.
2.
Clean off any oil, debris, or grass build-up on the
machine, especially under belt shields, around the
fuel tank, around engine and exhaust area.
Important:
You can wash the machine with
mild detergent and water. Do not pressure
wash the machine. Avoid excessive use of
water, especially around the engine.
Clean Debris Build-Up Under
Machine
Service Interval: Before each use or daily
1.
Stop engine, wait for all moving parts to stop, and
remove spark plug wire.
2.
To ensure the best performance, keep the
underside of the machine clean.
CAUTION
The machine may dislodge material from
under the housing.
•
Wear eye protection.
•
Stay in the operating position (behind the
handle).
•
Do Not allow bystanders in the area.
3.
Drain the fuel from the fuel tank. Refer to
Emptying the Fuel Tank
section.
4.
Tilt the machine rearward until the upper handle
rest on the ground and place a jack stand under
the machine.
Note:
It will take two people to tip the machine
rearward safely.
5.
Remove the debris with a hardwood scraper.
Avoid burrs and sharp edges.
6.
Return the machine to its upright position.
7.
Fill the fuel tank.
8.
Connect the wire to the spark plug.
Cleaning Under the Belt
Cover
Service Interval: Every 50 hours
1.
Stop the engine and wait for all moving parts to
stop.
2.
Disconnect the wire from the spark plug.
3.
Remove and retain the four bolts, lock washers,
and two spacers securing the belt cover to the left
side of the machine.
4.
Remove the cover and brush out all the debris
around the belt area.
5.
Reinstall the belt cover and tighten all hardware.
6.
Connect the wire to the spark plug.
Cleaning the Seed Gate
1.
Stop the engine and wait for all moving parts to
stop.
2.
Disconnect the wire from the spark plug.
3.
Drain the fuel from the fuel tank. Refer to
Emptying the Fuel Tank
section.
4.
Tilt the machine rearward until the upper handle
rest on the ground and place a jack stand under
the unit.
Note:
It will take two people to tip the machine
rearward safely.
5.
Clean the debris between the frame and the seed
gate.
6.
Lubricate the sliding surface between the frame
and seed gate with a dry lubricant.
7.
Return the unit to its upright position.
8.
Fill the fuel tank.
9.
Connect the wire to the spark plug.
Waste Disposal
Motor Oil Disposal
Engine oil is a pollutant to the environment. Dispose
of used oil at a certified recycling center or according
to your state and local regulations.
27
