36
4.1.4 Configure TBEN-LH-8IOL_QC_ON Connection
When the device is configured using a “
TBEN-LH-8IOL_QC_ON”
connection, the device is switched to the
QuickConnect (QC) mode. The device is “Ready for Connection” at 100msec time after the device power
cycle. The actual connection time depends on a controller setup and system architecture.
The QC_ON connection is configured as follows:
Create a new module as described in the section 4.1.2
Fill in the
Name
,
Description
and
Ethernet Address
of the device at
New Module
dialog page
Figure 4.7 – New Module configuration
Click “Change…” to open the “
Module Definition”
page
Use
“TBEN-LH-8IOL_QC_ON”
connection from the
Connection Name”
drop down list and select
INT data format at the
Size
drop down list, per Figure 4.8
Click
OK
to return to the previous dialog page
Click “
Apply
” and
“OK
at the
New Module
dialog page
Follow the dialog to save configuration, download program and go on-line.
Figure 4.8 – QC_ON Connection setup
Summary of Contents for TBEN-LH-8IOL
