turck LUS211 Series, Instructions For Use Manual, Page: 27 / 41

V01.00 | 2021/11
27
Explanation Options Function
ou4 Function of output 4 Hno Hysteresis function (NO = NO contact)
Hnc Hysteresis function (NC = NC contact)
Fno Window function (NO = NO contact)
Fnc Window function (NC = NC contact)
EF Submenu for additional
setting options See table “Parameters in the EF submenu”
9.2.9 Parameters in the EF submenu (Extended Functions)
Explanation Options Function
MODE Measured variable DIST Distance to the sensor
DPCT Distance to the sensor in % (scaled to Full-EMTY)
LVL Level
LPCT Level in % (scaled to FuLL-EMTY)
VOL Volume
VPCT Volume in % (scaled to FuLL-EMTY)
uniV
Volume unit
A
Liter
m³ Cubic meters
in³ Cubic inch
ft³ Cubic foot
gal Gallons
uniL
Unit of length mm Millimeters
m Meters
in Inches
ft Feet
GEOM
Geometry submenu For additional setting options for the container
geometry, see the Parameters in the GEOM submenu
table
Hi Maximum value memory The highest level is stored and can be displayed/
deleted (hold down [SET]).
Lo Minimum value memory The lowest level is stored and can be displayed/
deleted (hold down [SET]).
dSP1…
dSP4 Switch delay of
SP1…SP4 0…60 s in increments of 0.1 s (0 = delay time not
active)
Default: 0.0
drP1…
drP4 Switch delay of rP1…rP4 0…60 s in increments of 0.1 s (0 = delay time not
active)
Default: 0.0
dFH1…
dFH4 Switch delay of
FH1…FH4 0…60 s in increments of 0.1 s (0 = delay time not
active), only available with window mode Fno or Fnc
Default: 0.0
dFL1…dFL4 Switch delay of FL1…FL4 0…60 s in increments of 0.1 s (0 = delay time not
active), only available with window mode Fno or Fnc
Default: 0.0