turck BL67-GW-PN-AC, User Manual, Page: 34 / 119

Technical features
D301239 1013 - BL67 AIDA PROFINET 4-14
4.10.2 Channel -specific error codes of the I/O-modules
The channel-specific diagnostic messages of the I/O-modules using error codes are defined as follows:
Table 4-5:
channel-specific
error codes
Value (dec.) Diagnosis
Error codes (1 to 9 according to the standards)
1 Short circuit
2 under voltage
4 Overload
5 Over temperature
6 wire break
7 Upper limit value exceeded
8 Underflow lower limit
9 Error
Error codes (16 to 28 manufacturer specific)
16 Parametrization error/ configuration error
After a validity check, the parameter data are (partially) rejected by the module.
Check the context of parameters. Check the context of parameters.
21 Hardware failure
The module detected a hardware failure. Exchange the module.
22 Behavior at communication loss
The module detected a communication problem at its ports, e. g. RS232/485/422, SSI
or other interface. Check the connection or the function of the attached devices.
23 Direction error
The direction is detected to be wrong. Check the parameterization or the control
interface versus use case.
24 User software error
The module detected an user application software error. Cold-junction
compensation error
Re-initialize user the application software of the module.
25 Cold-junction compensation error
The module detected a defect or missing cold-junction compensation.
26 Overload sensor supply
The module detected a load dump at the sensor supply.
28 Common error
The module detected an error. Refer to the I/O-module manuals for a more detailed
description of possible errors. Error types can depend on the operation mode and the
parameterization.