Tunturi FitCycle 40, User Manual, Page: 23 / 104

23
English
‼ NOTE
• The console switches to standby mode when
the equipment is not used for 4 minutes.
Explanation Display functions
Time
- Without setting the target value, time will count
up.
- When setting the target value, time will count
down from your target time to 0 and alarm will
sound or flash.
- Without any signal being transmitted into the
monitor for 4 seconds during workout, time will
STOP
- Range 0:00~99:59
Speed
- Displays current training speed.
Maximum speed is 99.9 KM/H or ML/H.
- Without any signal being transmitted into the
monitor for 4 seconds during workout, SPEED
will display “0.0”
RPM
- Displays the Rotation Per Minute.
Display range 0~15~999
- Without any signal being transmitted into the
monitor for 4 seconds during workout, RPM will
display “0”
WATTS
- Display current workout watts.
- Range 0 ~ 999
LOAD
- Shows tension level setting, when adjusting
resistance, for 3 seconds.
Distance
- Without setting the target value, distance will
count up.
- When setting the target value, distance will
count down from your target distance to 0 with
an alarm sound or flash.
- Range 0.00~99.99
Calories
- Without setting the target value, calorie will
count up.
- When setting the target value, calories will
count down from your target calorie to 0 with
an alarm sound or flash.
- Range 0~9999.
‼ NOTE
• This data is a rough guide for comparison of
different exercise sessions which cannot be
used in medical treatment
Pulse
- Current pulse will display after 6 seconds when
detected by the console.
- Without any pulse signal for 6 seconds, console
will display “P”.
- Pulse alarm will sound when current pulse is
over the target pulse.
- Range 0-30~230 BPM
Explanation of buttons
Up
- Increase resistance level
- Setting selection.
Down
- Decrease resistance level
- Setting selection.
Mode
- Confirm setting or selection.
Reset
- In setting mode, press RESET key once to reset
the current function figures.
- Press RESET key and hold for 2 seconds to reset
all function figures
Start/ Stop
- Start or Stop workout
Body Fat
- Test body fat% and BMI in stop mode.
Recovery
- Test heart rate recovery status.
Opperation
Power on
- Plug in power supply to power on computer.
- Press any key to power on the console when
being in sleep mode..
- Start pedalling to power on the console when
being in sleep mode.
LCD will display all segments (fig. - F-01)