3
USER MANUAL
TUNVERLIF01
•
TUNVERLIF02
1. SAFETY GUIDELINES
Important:
Read and understand all safety instructions before use. Keep instructions safe for future reference. Ensure that this
equipment is in sound, clean condition and good working order before use. The operator must have a clear and unobstructed view
of the entire travel area before operating the lever block - it is preferable to operate with one or more persons on hand.
General Safety:
•
Always inspect equipment for damage before use
•
Ensure any damaged parts are replaced before use - use only Tundra Industrial recommended parts - contact your dealer for
advice
•
Do not use this equipment if damage or weakness is detected during inspection
•
Do not modify this equipment for any use other than that which it has been designed and tested for
•
Never exceed the rated capacity
•
Keep the equipment clean and well maintained for optimal, safe performance
•
Ensure that the working environment is well lit and kept clean and free from clutter, keep children and animals away
•
Ensure that the floor is level and strong enough (preferably concrete) to take the weight of the lift and the bike
•
This equipment should only be used by fully-trained and competent individuals (never under the influence of drugs or alcohol)
•
Raise and lower the load in a smooth, controlled manner
•
Use a qualified person to lubricate and maintain this equipment
•
Unauthorised parts may be dangerous and will invalidate the warranty
Equipment Safety:
•
Never use this equipment for lifting, supporting or transporting people or animals
•
Dot not use the clamp in areas containing flammable vapors, liquids, gasses or combustible dust or fibres
•
Do not use the clamp in highly corrosive, abrasive, wet environments or in applications involving exposure to temperatures
below -40°C or above 80°C
•
Keep children and animals out of the working environment during operation
•
Ensure that the nameplate / specification plate is kept clean, clear and visible at all times
WARNING:
Do not use this equipment if any damage or wear is detected - remove from service immediately and seek advice for
repair
•
Never lift under 20% of the rated capacity
•
Used on all hot rolled structural steel plates and sections up to a surface hardness of 300 Brinell/32 Rockwell C
WARNING:
No responsibility is accepted for incorrect use of this equipment. Incorrect use can result in damage to the equipment and
danger to the user. Warranty will be void in the event of incorrect use. The warnings, cautions and instructions discussed
in this instruction manual cannot cover all possible conditions and situations that may occur. It must be understood by the
operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the
operator.
