Tufner 8000 REPEL, User Manual

Page: 5 / 19

8000 REPEL
Digital Weight Indicator User Manual
5
LED Functionality – Blinking interval
During Power-up (Initialization) ON for 5 seconds
FULL BATTERY Blink interval
Working Mode 1.5 seconds
Sleep Mode (power sav-
ings) 4 seconds
LOW BATTERY Blink interval
Working Mode 10 seconds Double Flash
Sleep Mode 10 seconds Double Flash
Please replace the batteries when the blink interval is 10 seconds!
NOTE 1: TI-500 RFTM will shut down completely within two hours of a lost connection
with the indicator.
NOTE: 2: TI-500 RFTM will only enter sleep mode when the
8000 REPEL
indicator is
OFF.
When shipped from the factory, the
8000 REPEL
digital indicator is configured to
automati-cally switch off after 5 minutes if not in use.
2.5 Replacing the batteries – TI-500 RFTM
An optional cylindrical battery holder is available which requires 4 “C” cell alkaline bat-
teries.
1. Turn the TI-500 RFTM OFF (Press the RED button)
2. Locate the metal battery cylinder
3. Unscrew either end cap to reveal batteries
4. Exchange the batteries
– be careful to note polarity
5. Replace the end cap
6. Re-install the metal battery cylinder
2.6 Optional Rechargeable battery information
The
8000 REPEL
may contain an optional rechargeable battery which is internal to the
unit. Before using the indicator for the first time, please charge the battery overnight.
The indicator’s battery should operate for about 85 hours if left on continuously. The
display unit is configured to power down after 5 minutes of inactivity but this parame-
ter can be changed thru the A1-10 menu setting.
The battery can be charged while ON or OFF and the indicator can be operated while
it’s charging unless the state of charge is very low.