TL60ECV
-
Section 15: Option - Wireless Plastic Film Sensor 15-1
Section 15: Option - Wireless Plastic Film Sensor
Wireless Film Sensor Reciever Board Installation
Ensure all parts have been received. Refer to
Parts Manual
.
1.
Install film sensor reciever board casing to holes beside
ECU under right side fender. See
Fig.1
.
2. Plug supplied harness into bottom of reciever board
casing.
3. Follow the diagram in
Fig .2
to wire the loose wire
harness ends into bale wrapper’s main wiring harness.
• The cable wires marked ECU must be inserted into
their matching main harness connectors. You will need
to remove the backs of these connectors to insert the
wireless film sensor harness pins.
• Black and red power cables marked as “VEC” must run
to the control panel. The control panel and fuse box will
need to be opened.
Fig .2
NOTE:
All plugs shown from rear side.
Fig .1
Summary of Contents for TL60ECV
