1
2
3
4
5
6
8
7
9
10
TL60ECV
-
Section 6: Control Screen Operation 6-3
Setup Screen
Press Next Button once to display the Setup screen. See
General Button Functions
,
In the setup screen you may change settings to customize the wrapping operation. Use the selector
knob to select and modify values.
1. Switch Twin Wrap box to “YES” if you have installed this option (4 rolls instead of normal 2).
2. Target Wrap Layers : Change amount from 2-20 layers per bale.
3.
Enable/Disable the film sensor option as needed, see
4. Adjust time before power drive option auto disengages. Default is 10 seconds.
5. Turn off or change facing direction of laser guidance option if equipped, refer to
6. Change desired distance between bale rows if balewrapper equipped with optional laser guidance.
7. Set Bale Count Adjust to zero at start of new job.
8. Change to different length the ram will travel before the hoop starts rotating (default is 6”).
9. Change to different complete ram travel length (default is 42”).
10. Change to different preset bale widths (36”,48”,60”).
Summary of Contents for TL60ECV
