1
2
3
4
5
6
7
8
6-2
Section 6: Control Screen Operation -
TL60ECV
Manual Wrap Mode Screen Functions
1. Wrap Mode Function - Press to switch to Auto Wrap mode.
2. Powerdrive Enable Button - Press to enable optional Powerdrive. Use control panel knob to
complete desired drive operation. See Section ?? for more information.
3. Ram Reverse Button - Press and hold to push bale through wrap chamber.
4. Roller Bed Up - Press and hold to raise rear roller bed to full height.
5. Roller Bed Down Button - Press and hold to lower rear roller bed to ground.
6. Ram Forward Button - Press and hold to retract bale ram to front of machine.
7. Hoop Rotate Button - Press and hold with Ram Reverse Button to wrap bales manually.
8. Brake Button - Not applicable with model TL60ECV.
Control Screen Error Messages
If, while operating, you see an error message replacing the Tubeline decal, stop the machine and
check that the doors are fully closed and that the film has not ripped or emptied.
Summary of Contents for TL60ECV
