WARRANTY AND OWNER REGISTRATION
Your TUBE DRIVER is warranted for a period of THREE
FULL YEARS against defects to the original, registered
owner provided he/she has returned a completely filled-
out OWNER'S REGISTRATION CARD.
This warranty covers parts and labor only; shipping
charges remain the sole responsibility of the owner.
Damage due to modification or abuse is excluded from
this warranty. Before returning any unit for service, a RE-
TURNED MERCHANDISE AUTHORIZATION NUMBER
(R.M.A.#) must be obtained.
Manufacturer is not responsible for consequential or in-
consequential damages resulting from any application or
use of this product. Manufacturer and sales agents as-
sume no liability or responsibility for safety or injury relat-
ing to the use of TUBE DRIVER, and user agrees to hold
manufacturer and designer harmless in this regard. This
is the full extent of the warranty; no other warranties im-
plied or intended.
For service and return authorization contact:
7811 E. Pierce Street
Scottsdale, AZ 85257
Ph: 480-941-0705 Fax: 480-946-2412
910 TUBE DRIVER
You’ve just purchased the vintage tube overdrive pedal
that started it all—TUBE DRIVER! Please take a mo-
ment to look over this brochure, and be sure to send in
the owner’s registration and your comments.
Again from the leading innovator of the modern tube
overdrive, B.K. Butler, a major break-through in the
classic 12AX7A tube sound. The ability of the Tube
Driver to be powered from a common 9-volt battery
eliminator puts this pedal into your hands for under
$100.
Your new Tube Driver pedal operates from the same
type of battery eliminator as most of your battery-
operated effects (9-volt DC 200mA Min.), and it’s small
enough to fit in your pedal case.
The best thing about your Tube Driver is that instead of
bogus, cheap, solid state overdrive, you now have the
fat, warm, searing Real Tube sound.
OPERATION
Plug in a battery eliminator (9-volt DC 200mA Min.)
and allow the tube to “warm up” for about 15 seconds.
Then plug your guitar into the “In” jack, and your amp
to the “Out”. Set the Tube Driver, EQ and Level Out
controls to where your ears feel good, and you’re set.
(The red LED shows the Tube Driver is active.)
