Tube-Line NITRO 275RS, Operator'S Manual

Page: 43 / 49

9-1
Section 9 - Optional Endgate Indicator -
Nitro
Section 9 - Optional Endgate Indicator
With the optional endgate indicator the operator can see the height at which the endgate is raised. This can be
used to apply material at a precise rate.
Endgate Indicator Installation
There are several components in this kit requiring installation. Refer to the corresponding section in your parts
manual to ensure all parts have been included in the kit.
1. Fasten indicator assembly to
front frame tabs with 4 bolts
and nuts.
2. Run eyebolt cable end to right
rear side of manure spreader.
3. Use supplied bolts and nuts to
fasten rear pulley assembly to
frame tab nearest the endgate
cylinder. Pulley needs to
be pointed towards front of
manure spreader.
4. Replace existing top right
endgate cylinder pin with
supplied endgate indicator
cylinder pin and hex bolt.
5. Fasten eyebolt with supplied
hex nuts to endgate cylinder
pin. Adjust length of eyebolt to
apply tension to cable.
6. Mount cable guides to right
side frame tabs using supplied
hex bolts and lock nuts.
NOTICE: Number of guides
may vary for different manure
spreader models.
1
1
2
1
6
3
4
5
6
7. Use tractor hydraulic controls to raise and lower the manure spreader endgate test the function and
accuracy of the endgate indicator.
NOTICE: See next page for Operation sequence.