1.6. INSTALLING MIDI SOCKETS
5
Figure 1: SH-1oh1 processor board placement and orange wire location
Figure 2: Location of yellow and red wires
using the connectors. The red and green wires should be on top. The color
codes on the SH-1oh1 show the wire’s correct positions. Do not interchange
them!
You can use the color codes provided on the SH-1oh1 to install the
socket’s connectors properly. The midi in connector with black and white
wires is placed in the lowest position with the black wire facing up. The
midi out connector is placed beside it with the grey and purple wires facing
up. The uppermost connector is placed with the red and green wires facing
up.
1.6
Installing midi sockets
The midi sockets can be installed in various ways as they can be detached
from the SH-1oh1 board. You can install them from inside the case or on
the outside. You can also of course not drill any holes at all and just put
them in the battery compartment. The socket with two wires (black and
white) is the midi in socket, the one with the three wires is midi out.
