DIY Build Instructions – PLITKA TRACE (MINIATURE OSCILLOSCOPE)
First off, thank you for your purchase of the PLITKA TRACE DIY Kit. If you are a DIY Synth novice, you have selected a great module to
advance your skills. It is not as simple a circuit as the DISPRS or DIÔD OR, but still very doable. If you have built our BTN MASHR, you can
build this one. If you are a veteran (or, as we like to say at Tsyklon Labs - “Hero of Synthesizer DIY”), then this kit will be super fun.
First, let's make sure that you have everything on hand before we heat up the iron. The tools you will need are as follows:
- Soldering Iron and Solder
- Wire Cutters
- Wire Strippers
- Needle Nose Pliers
- Knurled Nut Tool (Xicon 382-0006) or Small Pliers for tightening 3.5mm knurled nuts
- 2.5mm Allen Key
- Adjustable Wrench or 5.5mm Nut Driver
- Lead Bending/Forming Tool (I like the Production Devices Model 801)
The following components have been provided in the PLITKA TRACE DIY Kit:
Quantity Part Description
1
Tsyklon Labs TRACE PCB
1
Tsyklon Labs TRACE Front Panel
2
M3 x 18mm Metric Black-Oxide Screw
2
M3 Locking Nut
2
M3 x 10mm Nylon Spacers
1
Futaba 3 wire servo cable with keyed J connector
DIY Build DOC/BOM
PLITKA TRACE
V 1.3
Page 1
