11 Operating QUESTempº 48N
Run
Run
For Data Logging setup, the run mode begins a session in memory and logs the data. For
Event Logging, each run/stop is stored as an event and a numeric counter displays the
number of saved events.
1.
Begin a session by pressing the
Run/Stop key
from the view mode (or measurement
view). An asterisk in the lower right corner indicates the run mode.
To toggle through the views, press the
Up or Down Arrow
.
GLOBE
90.3
º
F
05
RH
53.3
º
F
Run Indicator
Figure 1-14: Run mode indicator
2.
End the session by pressing the
Run/Stop key
again. (The session will stop recording
when the asterisk is no longer displayed.)
NOTE:
If the logging memory is full or if there are no sensors plugged into the unit,
attempting to enter the Run mode will result in an error message. If the memory
capacity is exceeded, the asterisk in the lower right corner of the display will turn
into an “F” and the memory remaining screen will show “0.0”.
