TSI Incorporated PORTACOUNT PRO+ 8038, Operation And Service Manual

Page: 32 / 107

26 Chapter 4
5. Record the results.
6. Using a Printer with the PortaCount Fit Tester .
7. Stand-Alone Fit Testing .
8. Advanced Database Tools .
Step 1
—Prepare the PortaCount Pro Respirator Fit
Tester for Fit Testing
Follow the steps below to setup the PortaCount Pro fit tester for fit
testing without using the Fit Test Software (stand-alone
mode).
Fill the Alcohol Cartridge
W A R N I N G
Isopropyl alcohol is hazardous material. Do not ingest or
allow alcohol to contact your eyes or skin. Refer to the
Material Safety Data Sheet (MSDS) located in the box of
alcohol for handling precautions and first aid
procedures.
Always recap alcohol fill capsule and other containers
immediately to prevent absorption of moisture and the
escape of alcohol vapors.
Dispose of any alcohol with visible contamination.
Because the Alcohol Cartridge is inserted into the Cartridge Cavity of
the instrument, it is critically important to keep it clean. Any dirt or
debris that gets into the PortaCount Pro fit tester can plug the small
internal nozzle and prevent operation. Do
not allow the black part of
the Alcohol Cartridge to make contact with any surface that may be
dirty. Keep the storage cap and alcohol cartridge clean.
Maintaining an adequate alcohol supply inside the PortaCount Pro fit
tester is critical to its operation and requires strict adherence to the
directions that follow.
1. Make sure the PortaCount Pro fit tester is turned off.
2. Remove the Alcohol Cartridge from the PortaCount Pro fit tester
by twisting it counter-clockwise.
3. Open the Alcohol Fill Capsule by twisting the Storage Cap off
(counter-clockwise).