TSI Incorporated Certifier FA Plus, Operator'S Manual

Page: 31 / 63

2: Setup and Operation 21
2.3.2 Graph Measurement Selection
Figure 20. Graph Measurement Selection Screen

To add a parameter to Graph, touch the parameter on the left and then
touch the top right direction arrow. Only two parameters can be graphed at
one time. The available parameters change depending on what module is
attached.

To remove a parameter from the graph, touch the parameter and then
touch the top left direction arrow.

To change the gas calibration used, touch the gas dropdown list and select
the desired gas.

To add a parameter to the label section below the graph, touch the
parameter and then touch the bottom right direction arrow. Only four
parameters can be in this section.

To remove a parameter from the Parameter Screen, touch the parameter
and then touch the bottom left direction arrow.

After clicking OK , a prompt will appear to enter the units of measurement.
Note: Up to two parameters may be graphed simultaneously; whereas up
to four parameters may be viewed simultaneously on the Graph
page.