TSC PEX-1121 Series, User Manual, Page: 61 / 95

56
6.3.1 SBPL
(
Only available on EZS version firmware)
Item Description Default
Print Type
This item is used to set the print mode. There are three modes as below,
Dispenser Once printer complete printing 1 label, it will wait for being
removed.
Rewinder mode The print engine prints without pausing between labels.
The media is wound onto a core after printing.
Continuous Print the specified number of media
Dispenser
Print Darkness
Use this item to setup printing darkness. The available setting range is from 0 to
10. You may need to adjust your density based on selected media.
3
Print Speed
Use this item to setup print speed. Available setting range is 2~18 for 203dpi,
2~14 for 300dpi and 1.5 ~6 for 600dpi.
203 dpi: 6 ips
300 dpi: 4 ips
600 dpi: 3 ips
Slew Speed Use this item to setup feed speed. Setting value is up to 8 ips.
203 dpi: 6 ips
300 dpi: 4 ips
600 dpi: 3 ips
BackFeed Speed Use this item to setup back feed speed. Setting value is up to 6 ips. 2 ips
Offset Adjust offset position 0 dot
Pitch Adjust print position 0 dot
Setting SBPL
Print Type
Dispenser
Rewinder Mode
Continuous
Print Darkness
Print Speed(S)
Slew Speed(S)
BackFeed Speed(S)
Offset
Pitch