TSC CPX4P Series, Service Manual

Page: 223 / 232

219
11) Confirm that ink is absorbed in the tip of Cleaning Stick. Then wipe off Printhead surface from front to
rear several times.
12) Remove Nozzle Check Pattern.
13) Close Upper Unit and print the Nozzle Check Pattern again to check if the white streak is eliminated.
14) Shutdown Printer as follows:
* Press and hold Power key down.
* Release Power key after a sound of the beep.
Confirmation of Printhead Position
Confirm that the relative mis-registrations among different colors are not observed in printed image. If
there should be the mis-registration, adjust Printhead positions via Service Utility or Printer Driver.
CAUTION:
•
Do not wipe the face of Printhead too hard. Wiping the surface too hard may cause damage
on the printhead.
•
Never touch the Printhead surface. Fatal damage may result on it.
NOTE:
It may take 30 sec. or more for shutdown sequence after releasing the Power key.