4.3. 3. VFD (Variable Frequency Drive)
The VFD (Variable Frequency Drive) supplies power to, and controls, the mixer motor.
The VFD requires single phase wiring from your electrical panel to the VFD, then 3 phase wiring from the
VFD to the mixer motor. TruSteel suggests placing a J-Box when contining the 3 phase wiring conduit
through the wall.
Parts List
1. Lenze VFD
2. Remote Control (includes 8 feet of CAT5)
Setup Required by Customer
1. Mount VFD to wall inside NON-C1D2 room
2. Run single phase electric into the VFD.
3. Run 3 phase electric to a j-box on the wall
4. Continue 3 phase electric from j-box to where mixer will “live”
5. On day of install, electrician will be required to land wires to mixer motor
TruSteel
DR-10 CUTSHEET AND OPERATING MANUAL - 1
Page 7 of 21
