TRUST 735S POWERC@M ZOOM
30
13 Troubleshooting
Method
1.
Read the solutions given below.
2.
Check for up-to-date FAQ’s, drivers and instruction manuals on
the Internet (www.trust.com/13675).
13.1.1
Problems with the camera
Problem
Cause
Possible solution
The camera is turned off.
Turn the camera on (see
chapter 6.1).
The batteries have been
inserted incorrectly.
Reinsert the batteries (see
chapter 5.1).
The batteries are empty.
Replace the batteries (see
chapter 5.1).
The camera does
not do anything.
Camera is still connected to
your computer.
Disconnect the USB cable.
The camera cannot be
operated when it is
connected to a computer.
The camera
cannot be turned
on.
No batteries have been
inserted.
Insert batteries onto the
camera (see chapter 5.1).
The camera does
not react, although
the batteries are
full.
The camera must be reset.
Disconnect the USB cable
and remove the batteries
from the camera. Reinsert
the batteries after
approximately 10 minutes.
The power in the batteries is
low.
Replace the batteries
The camera
suddenly turns
itself off.
NiCd batteries are used.
Use Alkaline or
rechargeable NiMH
batteries.
‘Card Error’
flashes on the
LCD screen.
The memory card has not
been formatted or has the
wrong format.
Format the memory card
(see chapter 6.4.3).
‘Please open lens
cover’ flashes on
the LCD screen.
The camera is in the
Camera mode and has been
connected to an IBM
compatible computer.
Slide the lens open to
record video clips.
‘Please open lens
cover’ flashes on
the LCD screen.
The camera is in the
Camera mode and has been
connected to a Macintosh
computer.
This mode is not supported
by Macintosh computers.
Set the camera to the Photo
or Playback mode.
‘Please unlock the
SD card’ flashes
on the LCD
screen.
The SD memory card is
locked so that it is write-
protected.
Unlock the card or use a
different SD memory card or
an MMC memory card.
!
