Trumpf BendMaster 150, Operator'S Manual

Page: 71 / 258

3.2 Floor lane
The floor lane is a linear guide system with belt drive. The Bend-
Master is moved on it in lateral direction.
The floor lane is the connection to the factory floor. It can be
modularly extended with 2000 mm elements. The maximum
length is 14000 mm (BendMaster (60)) or 16000 mm (BendMas-
ter (150)).
The covering of the floor lane is not designed for standing
on or storing parts on it!
Damage to the floor lane.
Ø Do not step on the covering.
Ø
Do not deposit any workpieces on the covering.
3.3 Arm
The arm consists of three individual parts, which are connected
to each other with joints. The arm is moved by the rail interpola-
tion of three drives.
Turned away from the press brake, the arm is used to load and
unload the BendMaster. The arm faces the press brake during
the bending process.
The loading and unloading area may also be positioned next to
the press brake. In this case, the arm also faces the brake press
during loading and unloading.
A BendMaster with conveyor system enables loading and
unloading from all sides.
Additional functions are possible in addition to the press brake,
e.g. backlighting table, if the floor lane is of sufficient length.
3.4 BendMaster switch cabinet
The BendMaster switch cabinet travels along the machine body
of the BendMaster. It is equipped with the controllers for the
servo-drives, an industrial PC and the control and power elec-
tronics for the sheet sensor.
This industrial PC controls the drive axes and evaluates the data
of the sheet sensor. The industrial PC is connected to the porta-
B579EN
2015-06-01 The most important assemblies
3
‐
7
Modularly extendable
NOTICE
Loading/unloading and
bending
Additional functions next to
the press brake
Traveling version