Trumpf BendMaster 150, Operator'S Manual

Page: 205 / 258

8. Errors and Messages
All errors and messages are stored in the control of the Bend-
Master. They can be called up in the >
Diagnostics menu.
8.1 Displaying and acknowledging errors
and messages
Both the red LED on the portable manual control unit and the
red signal lamp on the safety fencing will go on if there is an
error at the BendMaster.
1. Press > Diagnostics > Existing messages .
Fig. 39953
2. Press Alarms , Errors/messages to display each message
type individually.
3. Press Alarms , All to display all messages.
4. Mark the message to be acknowledged.
5. Press
Acknowledge .
8.2 Troubleshoot an error
1. Mark the error message to be acknowledged by pressing it
(it is displayed in the footer).
2. Press Cause to display the possible error cause.
B579EN
2015-06-01 Errors and Messages
4
‐
111
Show
Acknowledge