Trumpf BendMaster 150, Operator'S Manual

Page: 194 / 258

Displaying axis positions
1. Press View , Positions . The axis positions are displayed in the
selected displayed coordinate system.
2. Press View , Show none . Displaying the axis positions is
deactivated again.
6.14 Starting a run-in program
Conditions
■ Loading and unloading stacks have not been changed since
the Run in.
■
The setup plan of the TruBend, including the regripping sta-
tion, has not been changed since the run in.
■ The correct gripper is loaded at the BendMaster.
■ All axes have been referenced. (see "Referencing the Bend-
Master", pg. 4
‐
39) .
■ The program has been run in.
■ The system is ready for operation in automatic mode.
■ No error messages, i.e. green LED on the portable manual
control unit lights up (acknowledge error if red LED is on).
■ BendMaster is ready for operation (the GREEN button was
pressed, and the "BendMaster“ icon is green).
1. Press > Set up > Job :
2. Select the job to be executed in the "Selected Order" list.
The selected job is opened and graphically displayed. Now it
can be further processed.
Tip
If the job is clicked on again, it is closed.
3. Press PositionAutomatic :
4
‐
100
Running in a TruTops program 2015-06-01
B579EN
Opening and starting the
program