Trumpf BendMaster 150, Operator'S Manual

Page: 149 / 258

Name Description
Material ID (store) ID number of the material with which it was
booked in the storage system. Only when a
storage system link is used.
Rotation to Geo Only when a storage system link is used and
up to TruTops Bend Software version 2.1:
If the part is is rotated in TruTops Bend in com-
parison with the geometry file, then this rotation
must be entered accordingly. The rotation to the
Geo drawing is possible only in 90° increments.
The rotation is carried out automatically starting
with TruTops Bend Software version 2.2.
Weight The sheet weight calculated by TruTops is dis-
played.
Layer thickness The layer thickness of the intermediate layer is
displayed and can be modified. A modification
of the sheet thickness has an effect only on the
calculation of the stack height.
Material The material programmed in TruTops Bend is
displayed.
Unprocessed material or intermediate layer part Tab. 4-9
Name Description
Material ID (store) ID number of the material with which it was
booked in the storage system. Only when a
storage system link is used.
Finished part Tab. 4-10
19. Press Back to return to the > Run in > Job menu.
Note
■ A job can be deleted only if it has not been opened or
loaded.
■ Deleted jobs can not longer be produced.
■ Jobs can be archived prior to deletion.
20. Press > Job > Delete .
21. Select the desired job .
22. Press
OK . The selected job is deleted.
23. Press > Job > Load . The selected job is loaded and displayed
in the header.
24. Press > Job > Unload . The loaded job is deselected.
6.5 Archiving, restoring or deleting jobs
Notes
■
A job can be archived only if no other job has been transfer-
red or loaded.
B579EN
2015-06-01 Running in a TruTops program
4
‐
55
Deleting a job
Loading a job
Deselecting a job