Support: 1-855-473-7449 or 1-408-943-4100
Email:
Page 6
Do not plug the power cords into a power outlet yet.
Connect a power cord to the back of one power supply.
Place the cord in the plastic clamp and press the tab into the latch to lock it in place. Repeat the process for the
second power supply and cord.
5 Connect Power Cables
5.1 Programming the ES24 Power Loss Mode
The ES24 can be programmed to automatically restart if the power input has been lost and subsequently restored.
By default, if the ES24 loses power it does not automatically start when power has been restored. The power button
must be pressed to turn the system on. However, the ES24 can be set to automatically restart when power is
restored to the system.
To activate this mode, quickly press the power button three times.
The power button blinks to indicate the current mode. When it is blinking quickly, the system automatically starts
when power is restored. When the button is blinking slowly, you must manually power on the system after a power
loss event. To test the current setting, disconnect the power, wait a few moments, and plug the system back in.
