10
4 STANDARD WIRE CROSS SECTION
4.1 SETTING THE TERMINALS
1. Loosen the clamp screw by rotating it counterclockwise (red circle).
2. Place the wire into the V groove vertically (below photo).
The sample shoud be straight up, not bending to the left/ right or up/ down
3. Rotate the screw clockwise to tighten the terminal firmly.
At Clamp Transfer Unit:
4. Pull the lever down
5. Place the clamp on the transfer unit.
Align the clamp fixing hole with the cylindrical
pin.
6. Release the lever.
※
Each type of clamp is designed to have 2
holes on its body:
●
Fixing hole:
Used when placing the clamp
on the transfer unit.
●
Fitting hole:
Used when placing the clamp
on the clamp holding stand.
Cylindrical Pin
Fitting hole
Fixing hole
