48
9
» Y081564 - (EN - REV. 003) | JUNE 2022
CALIPER BEARINGS REPLACEMENT
9.3.1
Removal of Guide Sleeve (6a; Rubber bush or 6b;
Floating Bearing
9.3.1.1 If present, remove guide pin (4).
9.3.1.2 Clean the area around the bearing.
9.3.1.3 Prepare tool combination (
R
1
) with (T06)
Ø39 mm
.
9.3.1.4 Place tool (
R
1
) in position on the caliper. Hand tighten
(T22) (see Fig.).
9.3.1.5 Hold (T22) using a ring-spanner 24 A/F and pull-out
the rubber bush (6) by turning tool (T20) with a suitable tool
(see Fig.).
9.3.1.4 - 9.3.1.5 - Removal of guide sleeve (6a/b)
Removal of Floating Bearing Variants
9.3.2
Removal of Double Roll Bearing (6f)
9.3.2.1 Remove the guide pin (6f.4) from the double roll
bearing (6f) by pushing from the outside (arrow
A
)
to inside
(see Fig. ).
9.3.2.2 Using a suitable tool, trim off inner-boot as close to
the caliper as possible. Take care not to damage the caliper
surface.
9.3.2.2 - Trim off inner-boot
9.3.2.1 - Remove guide pin
(R
1
)
6a/b
(Ø 39 mm)
T06
T22
T20
6f.4
A
