34
7
Siehe
Kapitel 2.3
46
16
< 30 mm
XX
Y
» Y081564 - (EN - REV. 003) | JUNE 2022
TAPPET AND BOOT ASSEMBLIES (13) AND INNER SEALS (22) REPLACEMENT
The sealing surface for the inner seal (22), must not be
damaged else the caliper must be replaced.
7.2.2 - Clean area and remove inner seal
7.2.3 - 7.2.5 - Wind out threads, inspect, grease threads and wind back
7.2 Replacement of Inner Seals (22)
7.2.1 Fully wind back the threaded tubes (16) by turning the
shear adapter (61) (see Section 6.1.4).
7.2.2 Clean area of the inner seal (22) and then, using a suitable
lever (
Y
)
, carefully remove the inner seal (22) (see Fig.).
7.2.3 Clean sealing surface (
X
) (see Fig.).
7.2.4 Wind-out the threaded tubes via the shear adapter
(61) to a maximum of
30 mm
whilst at the same time inspecting
them for corrosion or damage (see Section 7.1.5 -7.1.6)
7.2.5 Lubricate threads with white grease (Part No.
II14525, K093430 or II32868) and then wind back the
threaded tubes until they stop (see Fig.).
7.2.6 Fit new inner seals (22) onto the threaded tubes (16) and
carefully push into position.
See Section
2.3
Grease
16
22
