Tru-Turf RB48-11A Golf Green Roller, Original Instruction Manual

Page: 43 / 56



Smoothing Roller Bearings & Seals - Replacing
ROLLER ASSEMBLY INSTRUCTIONS
1. Lightly press one of the supplied new bearings into the end cap of the roller.
2. Slide the shaft into the roller and thru the bearing.
Install a circlip against the bearing ensuring it is correctly seated in the circlip groove in the end cap.
3. Repeat steps 1 & 2 for the other end.
4. Fit the supplied new inserts (2 per roller supplied) into each end cap, note that the holes must face out, lightly press
each insert intil seated against the shoulder in the roller tube end cap.
5. Apply a smear of grease to the face of the inserts and on the ends. This is to prevent the seals from being damaged
due to friction and to assist with sliding the seals onto the shaft.
6. Slide the 'V' seals back onto the shaft at each end, until they contact the insert.
Ensure the lip of the seal is facing and against the insert.
7. Slide a plastic washer (previously removed) on to the shaft, one (1) at each end.
8. Fit the circlips (previously removed) on to the shaft, one (1) at each end.
9. Before reinstalling the roller into the smoothing head, check that the roller turns smoothly on the shaft but with a
slight resistance.
NOTE - TWO (2) ADDITONAL CIRCLIPS ARE INCLUDED IN THE KIT IN CASE OF DAMAGE.
&,5&/,360867%(6($7('
&255(&7/<,172*5229(6
127(
+2/(60867
)$&(722876,'(
127($33/<$60$//$02817
2)*5($6(727+,6)$&(
127(/,32)6($/0867)$&(,16(57