_____________________________________________________________
6-2
NetWare Network Configuration
Default NetWare
Print Server
Name for all models
except most LN03 models
_
xxxxxx
_P1
Default NetWare
Print Server
name for all LN03 print servers
except XConnect 100 (XConnect 100 LN03 models use
_
xxxxxxx
_P1)
_
xxxxxx
_LN
NDS
Printer
name for first Serial Port (S1), if present
_
xxxxxx
_S1
NDS
Printer
name for second Serial Port (S2), if present
_
xxxxxx
_S1
NDS
Printer
name for second Parallel Port (P2), if present
_
xxxxxx
_P2
The queue server configuration process is as follows:
1. Make sure that you are logged in as ADMIN or equivalent (NetWare
4.xx and above) or SUPERVISOR (NetWare 2.xx and 3.xx). Install
the XAdmin32 software from the
TROY Print Server Software
CD-
ROM by clicking on the
Start
button and selecting
Run
. Click on
Browse and
select the CD-ROM drive. Open the Utilities folder,
open the XAdmin32 folder, and click on SETUP.EXE, Click
OK
twice and follow the instructions on the screen.
2. Click on
Start
, select
Programs
, select the
XAdmin32
folder, and
then select
XAdmin32
.
3. Click on the IPX/SPX icon under Filters to set the operating mode to
IPX/SPX (TCP/IP mode will not allow you to configure NetWare
print queues directly). The TROY external print server should
appear in the list of available printers (the name will one of the ones
listed in the
Default Print Server Names
section at the beginning of
this chapter). If it does not, try going to the menu bar and selecting
Devices
and then
Search Active Devices
.
Important Note:
V373 and earlier firmware do not support more
than one service and one port (the firmware version is listed on the
self-test page). If you have an XConnect II or XConnect 100 and
need to use the serial port for printing, you must upgrade to a newer
revision of the firmware.
4. Double click on the printer that you wish to configure, enter the
configuration password (ACCESS is the default), and press
OK
.
5. A series of index card tabs will be displayed. Click on the
NetWare
P1
tab to configure the MIO/EIO/first parallel port, the
NetWare S1
tab to configure the first serial port, the
NetWare P2
tab to configure
the XConnect 100 second parallel port, or the
NetWare S2
tab to
configure the XConnect 100 second serial port.
