Tire Pressure
Check the air pressure in both tires every 30 operating hours.
Deflate or inflate both tires evenly to 15- to 20-PSI (pounds per
square inch).
Be sure that both tires have the same air pressure or the tiller will
tend to pull to one side.
Air Filter
Refer to the Engine Operator’s Manual supplied with your tiller
for complete air cleaner service and maintenance information.
Battery
WARNING!
When removing the battery, always
disconnect the negative (-) cable first followed by
the positive (+) cable. Reverse this procedure when
reinstalling the battery.
The battery is sealed and is maintenence free. Acid levels cannot
be checked.
Always keep the battery cables and terminals clean and
free of corrosive build-up.
After cleaning the battery and terminals, apply a light coat
of petroleum jelly or grease to the terminals and cover
both terminals with the rubber boots.
Tine Shaft
After every 10 operating hours, remove the left- and right-side
Bolo Tine holders and clear away dirt and debris that have
accumulated on the tine shaft or inside the tine holders. Please
follow this maintenance recommendation, as debris can cause
premature wear to the tine shaft and its oil seals. Refer to the
previous tine holder removal instructions. After cleaning away
any debris and removing old grease from the tine shaft, apply
fresh grease to the tine shaft.
Wheel Shaft Maintenance
After every 10 operating hours, remove the wheels and clear
away dirt and debris that has accumulated on the wheel shaft
Please follow this maintenance recommendation, as debris can
cause premature wear to the wheel shaft and its oil seals.
Prop the transmission up with a sturdy block to raise the
wheels off the ground.
Remove the wheels by removing the hex bolt and lock nut
which secures each to the wheel shaft.
After cleaning away any debris and removing old grease,
apply fresh grease to the wheel shaft before re-installing
the wheels.
Hardware
Check for loose or missing hardware every ten (10) operating
hours. Failure to tighten or replace fasteners can cause poor
performance, equipment damage or oil leakage. Most hardware
on your tiller is visible. Pay particular attention to hardware listed
below.
•
•
1.
2.
3.
Transmission Pulley Mounting Bolt
If the washer behind the bolt head is loose, the bolt
needs tightening. To do this, first insert a punch or thick
screwdriver into the hole next to the bolt and wedge the
tool against the side of the motor mount casting. This
immobilizes the pulley while you tighten the bolt. See Fig.
6-1.
Neutral Plunger Assembly Jam Nut
The jam nut is located is located on the left side of the
neutral plunger. If loose, immobilize bolt head with one
wrench and use another wrench to tighten the nut. See Fig.
6-2.
•
•
Mounting Bolt
Figure 6-1
Jam Nut
Figure 6-2
26
s
ectiOn
6— M
aintenance
& a
djustMents
Summary of Contents for 682
Page 43: ...Notes 11 43 ...
