Troxler RoadReader Plus 3450, Manual Of Operation And Instruction

Page: 183 / 201

Appendix H–2
WINDOWS HYPERTERMINAL
To print (upload) data from the gauge to a computer equipped with
a Microsoft Windows operating system, use the
HyperTerminal
program as described in the following sections.
HYPERTERMINAL SETUP
To configure the Windows HyperTerminal program and set up a
dedicated icon to transfer data from the gauge, perform the
following steps:
1. Click on the Start button, select the Programs menu, and then
the Accessories folder.
►
In Windows 95, select the HyperTerminal icon.
►
In Windows 98 and later versions, select the
Communications subfolder, and then select the
HyperTerminal icon.
2. From the
HyperTerminal
window, double-click on the
Hypertrm
icon. The
Connection Description
window is
displayed. This window is used to set up a new connection.
3. In the
Name
box, enter a name (for example, Troxler Data ) for
the new connection. Select an icon to use for the connection,
then click
OK
. The
Connect To
window is displayed.
4. In the
Connect To
window, do not enter a telephone number.
Instead, select Direct to Com1 , Direct to Com2 , Direct to
Com3 , or Direct to Com4 , depending upon the computer.
The COM# Properties window is displayed, where # is the
number of the selected COM port.
5. Configure the
Port Settings
as follows:
Bits per second 9600
Data bits 8
Parity None
Stop bits 1
Flow control Hardware