Troxler Enhanced RoadReader Plus 3451, Manual Of Operation And Instruction

Page: 51 / 247

3–16
ROADREADER PLUS MAIN MENU
NOTE
To ensure proper communications between the PDA and
gauge, always power the gauge on before starting the
RoadReader Plus software.
To start the RoadReader Plus software, press the
〈
Troxler 3451
〉
button on the
Troxler
menu (see Figure 3–4 on page 3–10). The
software displays a splash screen that includes the software version
and gauge serial number. The software then establishes Bluetooth
wireless communications between the PDA and gauge.
When communications have been established, the software checks
the leak test interval and the date of the last leak test stored in the
PDA memory (see page 5–11). If the leak test interval has been
exceeded, the software displays
Warning! Leak test is due.
If
this warning appears, perform a leak test (see page A–13 and update
the leak test date (see page 5–13). Press the
〈
ok
〉
button to continue.
The software then checks the date of the last gauge calibration. If
the gauge is due for calibration, the software displays
Warning!
Calibration is due.
If this warning appears, Troxler recommends
returning the gauge and PDA to the nearest service center (refer to
page C–
Error! Bookmark not defined. ) for calibration. Press the
〈
ok
〉
button to continue.
The software then communicates with the gauge to check the status
of the gauge battery. If the PDA cannot establish communications
with the gauge, the PDA displays
Error! Checking Battery
Voltage. If this error message is displayed:
✓
Check that the gauge is powered on.
✓
Ensure that the gauge was powered on before the RoadReader
Plus software was started.
✓
Ensure that the PDA is within 4.6 m (15 ft) of the gauge.
✓
Verify the PDA’s Bluetooth communications configuration as
described on page 3–14.
✓
Verify the PDA’s ActiveSync configuration as described on
page 3–13.