Troxler EGauge 4590, Manual Of Operation And Instruction

Page: 140 / 186

A-12
M
M
e
e
c
c
h
h
a
a
n
n
i
i
c
c
a
a
l
l
M
M
a
a
i
i
n
n
t
t
e
e
n
n
a
a
n
n
c
c
e
e
The following procedures should be performed to keep the
Model 4590 gauge in good working order. If a serious problem
with the gauge arises, contact the nearest Troxler Service Center
or representative for instructions.
For a list of Troxler and authorized Troxler service centers, refer
to the front of this manual or visit the Troxler website at
www.troxlerlabs.com
.
Cleaning the Base and Topshell
If the Model 4590 gauge is to provide precise and accurate
measurements over a long period of time the gauge should be
kept as clean as possible. Monitor the outside surfaces of the
instrument for accumulations of dirt, oil, or any other foreign
matter. If a build-up of material is visible on the gauge base or
topshell, use the following procedures for cleaning:
To clean the gauge base, use a putty knife to scrape away any
built-up accumulations of soil.
Be careful not to damage the
gauge base!
After removing any large accumulations, wipe the
gauge base with a cloth soaked in BindOff, WD-40 or similar
non-corrosive cleaner to remove the remaining debris.
The topshell may be cleaned with mild (low alkaline) soap and
water. Other approved cleaning substances include methyl,
isopropyl, or isobutyl alcohols.
CAUTION
Cleaners and lubricants can damage the keypad. Do
not allow these chemicals to make contact with the
keypad!